Cat 345· This brand new CAT 345 was converted for D.H. Griffin Wrecking. · The three-piece stick and boom design allows the machine to raise to its full height within close range of the target. · The entire machine is joystick-controlled making it easy to learn and easy to use. · The machine is equipped to handle hammer, grapple, and shear attachments. 
|
Cat 345· With full operable extension at 85 ft. operators can reach higher and stay closer than any unmodified demolition machine. 
|
Cat 345· Cab rotation of up to 35 degrees allows for easy visibility while operating the machine at full reach · Also seen here is a removable counter-weight 
|
Cat 345· The stick and boom were built new by Norris Manufacturing for this machine and can even be removed and replaced with a standard excavator boom. 
|
Cat 365· This CAT 365B-II will reach 130' high and is equipped with a Labounty UP20 Demolition Jaw · The entire machine is joystick-controlled making it easy to learn and easy to use. · The machine is equipped to handle hammer, grapple, and shear attachments. · Cab rotation of up to 35 degrees allows for easy visibility while operating the machine at full reach 
|
Cat 365· View from above of Cat 365 
|
Cat 365
|
Cat 365· Tilt Cab 
|
Deere 750
|
Deere 750
|
Kobelco SK400· This Kobelco SK400 MK-IV will reach 90' high and is equipped with an Allied Universal Processor. · The machine is equipped to handle hammer, grapple, and shear attachments. 
|
Komatsu PC200
|
Komatsu PC300· Two Komatsu 300s converted for D.H. Griffin Wrecking. Shown here shearing the Rivergate Convention center in New Orleans, LA. Standard wrecking cranes could not be used because of a weight and demolition restriction to preserve the parking garage under the building. Norris Manufacturing's cranes met all of D.H. Griffin’s needs and helped them complete the project ahead of schedule. · Every Norris Manufacturing demolition machine has standard track gauge– rather than widen tracks, counterweight is used for stability. · With counterweights there is minimal wear on the swing bearing resulting in longer life and saved maintenance. 
|
Komatsu PC300· Boom and stick extension allows the machine to reach up to 70 ft. 
|
Komatsu PC300· Stick, boom ,and rotating shearing attachment are all hydraulic joystick controlled. 
|
Komatsu PC400· Converted from an excavator to a demolition machine for Stanton Demolition in Eugene, Oregon. · This machine was later modified to a hinged boom for versatility. · It can change length and add sections with the same stick. · With a special pin on the stick, extra sections can be added or removed just by pinning into place. 
|
Komatsu PC400· This machine also has an excavator boom easily interchanged with the straight demolition boom, and it all folds down for easy transportation. 
|
Komatsu PC400
|
New Holland EC600· 110' reach 
|
Komatsu PC200
|
Komatsu PC200
|
Komatsu PC200
|
Komatsu PC200
|
Komatsu PC600· Tilt cab 
|
Komatsu PC600· Folds up for easy transport 
|
Komatsu PC600
|
Komatsu PC600
|